Panzer4 Turret Roof Armor Thickness

The front turret armor was 16 mm at a 10 angle while the sides and rear were 14 5 mm at 25 angle and the top was 10 mm at 83 90 angle.

Panzer4 turret roof armor thickness. D were produced with 50 mm. The last 68 ausf. Armor thickness is rounded to the nearest integer with halves rounding up for odd integers and down for even ones. Note some descriptions of panzer iv armor layouts distinguish the front hull the superstructure and the turret.

J were produced without face hardened armor and the superstructure roof was thickened to 16 mm. The front glacis was 25 mm thick. Armor on the lower hull front. Turret armor thickness allows turrets to be armored and works exactly like armoring ships or magazines.

The armor on the front sides and rear of the turret was 30 mm thick. G were produced without the added 30 mm. The rounded gun mantle was 50 mm thick. Panzer ivs up through the f1 model used short 75l24 guns and had a maximum frontal armor thickness of 50mm on both the turret front and the front hull.

According to declassified documents from the cia a measurement of the t 72 turret at the port of the coaxial machine gun revealed an armor thickness of 350 milimetres. The british matilda ii was also heavily armored with at least 70 mm 2 76 in of steel on the front and turret and a minimum of 65 mm on the sides 79 but were few in number. Preference given to data from jentz. The next big change was a weak spot in the right side of the casting where a thin spot was made while machining the turret for the gun mount was discovered and armor was welded on the outside of the turret to thicken it back up.

Based on a scale drawing probably taken from the t 72 manual the turret armor was estimated to be 475 mm thick at the turret cheeks. The turret s armor protection was considered insufficient. Depending on the source the front armor thickness of the turret varies between 15 to 20 mm. 30 mm armour was used on the hull sides lower hull rear and front.

50 mm anti radiation liner 40 mm thick roof armor 80 mm polyurethane 2 mm steel 7 mm explosive 2 mm steel 10 mm high hardness steel or 191 mm of armor of which 90 mm are part of the turret roof and 101 mm applique armor. It is based on the total size of the turret the empire s best researched armor type and the armor thickness. The commander s cupola had all around 14 5 mm of armor with the two hatch doors being 8 mm thick. The rounded gun mantlet deflected shots into the thin hull roof.

The design has a narrower turret front and an external rangefinder located in a bulge on the turret. The turret lacked an internal rangefinder. The somua s35 had a maximum armor thickness of 55 mm 2 2 in while the kwk 37 l 24 could only penetrate 43 mm 1 7 in at a range of 700 m 2 300 ft. In february 1944 rheinmetall presented a suggestive design.